Shore Shot Tungsten Break-Off Points For Easton X10 & ProTour
Shore Shot Tungsten Break-Off Points For Easton X10 & ProTour
Points Fit - Easton X10 , Easton X10 Pro Tour, and any arrows that accept Easton Tungsten Points
90 Grain Points (3 Break-offs 80gr., 70gr., and 60gr.)(ONLY AVAILABLE IN GOLD)
100 Grain Points (Solid NO Break-offs)
120 Grain Points (2 Break-offs 110gr. and 100gr.)
140 Grain Points (2 Break-offs 130gr. and 120gr.)
Shore Shot Archery’s Take on Tungsten Points
Each point individually weighted and packaged
Tungsten break-off point for X10 & X10 ProTour shafts
60 to 140 grain verities
Titanium plating
Glue Cutout Below Head of Point For Better Fitment Into Arrow Shaft
6 Grooves For Better Glue Adhesion
Sold as a 12 pack
Weight tolerance: ± 0.5 grains (Matched Per Dozen ± 0.3)
97% Tungsten
OD .125”
Records
Individual Paralympic Gold Medal
Mens Recurve Double 70M 1, 367
WHY Titanium Plating?
Reasons to implement a titanium electroplating process include enhancing the metal's ability to resist surface fatigue and fretting and anti-galling properties. Titanium substrate plating can also be used to improve the following scenarios: Corrosion resistance in hot acidic environments.
WARNING: cancer and reproductive harm - www.P65Warnings.ca.gov
*Color may ware after extensive use
*Hitting objects other then target bales may cause point damage or breaks
*Reminder, EU customers will be responsible for paying VAT on pickup.
*Purchases outside of the United States may be subject to local taxes on delivery
Recommended Point Installation Method
(Tool Required: A butane or propane torch with small flame, pliers, cleaning materials noted below, and recommended hot melt (CDM Flitemate Hot Melt)
Cut arrow shaft on high speed arrow saw and deburr the inside of shaft, removing no more then 1/4” of aluminum shaft wall
Clean the inside of the shaft (about 2” in) with 91% isopropyl alcohol
Heat hot melt in a gas flame and apply a ring of hot melt around and inside the open end of the shaft (Never Apply Heat Or Flame To The Shaft)
With your small set of pliers, grasp the point and coat the shank end of the point with hot melt that was headed by your hot flame (get hot melt soft not liquid)
Hold the point in your piers with the hot melt applied into the flame again, this time let it liquefy (MAX 3-4 Seconds Do Not Overheat the Point) Serious damage to the shaft or point could occur
Put point into shaft with a twisting motion. Quickly reheat THE POINT ONLY IF NEEDED to get in fully into the shaft. Whip excess glue with a paper towel
Stand the shaft on the point end making sure the point is completely seated in the shaft and allow it to cool before touching our shooting, DO NOT use water to cool the shaft and point
Adjusting Point Weight
Required Tools: 2 Small Pliers and Safety Glasses
Only applies to 120 grain and 140 grain points
To remove 1st break-off (lose 10 grains) Use one pair of pliers to grasp the INNERMOST weight segment and with the other pair of pliers break off the outermost segment
To remove 1st and 2nd break-off (lose 20 grains) Use one pair of pliers to grasp the shank of the point and with the other pair of pliers break off both weight segments