Shore Shot Tungsten Break-Off Points For Black Eagle Revelation Shafts

BE Black 140 Family 2.jpg
BE Black 140 A.jpg
BE Black 140 B.jpg
BE Black 140 C.jpg
BE Black 140 D.jpg
BE Black.jpg
BE Black 140 Family 2.jpg
BE Black 140 A.jpg
BE Black 140 B.jpg
BE Black 140 C.jpg
BE Black 140 D.jpg
BE Black.jpg

Shore Shot Tungsten Break-Off Points For Black Eagle Revelation Shafts

from $120.00

Points Fit - Black Eagle Revelation, and any arrows that accept OD .125” point shanks

Shore Shot Archery’s Take on Tungsten Points

  • Available in size A (300 Spine), B (350-400 Spine), C (450-550 Spine), and D (600-800 Spine)

  • Each point individually weighted and packaged

  • Tungsten break-off point for Black Eagle Revelations shafts

  • 140 to 100 grains (with 4 break-offs)

  • Titanium plating

  • 6 Grooves to improve gun adhesion in arrow shaft

  • Glue Cutout Below Head of Point For Better Adhesion In Arrow Shaft

  • Sold as a 12 pack

  • Weight tolerance: ± 0.5 grains (Matched Per Dozen ± 0.3

  • 97% Tungsten

  • OD .125”

WHY Titanium Plating?

Reasons to implement a titanium electroplating process include enhancing the metal's ability to resist surface fatigue and fretting and anti-galling properties. Titanium substrate plating can also be used to improve the following scenarios: Corrosion resistance in hot acidic environments.

WARNING: cancer and reproductive harm - www.P65Warnings.ca.gov

*Color may ware after extensive use

*Hitting objects other then target bales may cause point damage or breaks

Spine:
Quantity:
sale
Add To Cart

Recommended Point Installation Method

(Tool Required: A butane or propane torch with small flame, pliers, cleaning materials noted below, and recommended hot melt (CDM Flitemate Hot Melt)

  • Cut arrow shaft on high speed arrow saw and deburr the inside of shaft, removing no more then 1/4” of aluminum shaft wall

  • Clean the inside of the shaft (about 2” in) with 91% isopropyl alcohol

  • Heat hot melt in a gas flame and apply a ring of hot melt around and inside the open end of the shaft (Never Apply Heat Or Flame To The Shaft)

  • With your small set of pliers, grasp the point and coat the shank end of the point with hot melt that was headed by your hot flame (get hot melt soft not liquid)

  • Hold the point in your piers with the hot melt applied into the flame again, this time let it liquefy (MAX 3-4 Seconds Do Not Overheat the Point) Serious damage to the shaft or point could occur

  • Put point into shaft with a twisting motion. Quickly reheat THE POINT ONLY IF NEEDED to get in fully into the shaft. Whip excess glue with a paper towel

  • Stand the shaft on the point end making sure the point is completely seated in the shaft and allow it to cool before touching our shooting, DO NOT use water to cool the shaft and point